Connecting your camcorder to your computer – Introduction
If you cannot install the USB
The USB driver has been registered incorrectly
as your computer was connected to your
camcorder before the installation of the USB
driver was completed. Perform the following
procedure to install the USB driver correctly.
Disconnect your camcorder from the
computer following "To disconnect the
USB cable" (page 97).
Install the USB driver again following
"Installing the USB driver" (page 92).
After "InstallShield Wizard complete"
dialog box disappears, restart your
Connect your camcorder to the
computer following "Connecting your
camcorder to the computer" (page 94).
The USB driver installation and the
connection between your camcorder
and the computer is completed.
Consulting the on-line help
An ImageMixer on-line help is available where
you can find detailed operating instructions
for ImageMixer software.
located at the top right of the
Or, click [Start] t [Programs] ([All
Programs] in Windows XP) t
[PIXELA] t [ImageMixer] t [Help].
The ImageMixer Help window appears.
Find the information you need from the
table of contents.
To close the on-line help
button at the top right of the
If you have any questions about ImageMixer
ImageMixer is a product of PIXELA
Corporation. For details, refer to the operating
instructions of the CD-ROM supplied with