Troubleshooting - Flymo Mighti-Mo 300 Li Original Instructions Manual

9
Problem
Tool fails to operate
Motor starts and stops
immediately
Tool functions
intermittently
Product leaves
ragged finish
and/or
Motor labours
Area of cut (battery
duration) not large
enough
Cutting blade not
rotating while garden
product switched on
Excessive vibrations/ noise
No charging procedure
possible
The charger control light
does not light up after
inserting the mains plug
into the socket

Troubleshooting

Possible Cause
Possible clogging
Battery not fully charged
Battery not inserted (properly)
Grass too long
Motor protector has activated
Battery too hot/cold
Isolator key not inserted correctly/fully
There is a short delay in the motor
starting after engaging the On/Off switch
Battery not fully charged
Isolator key not inserted correctly/fully
Battery not inserted (properly)
Battery too hot/cold
Internal wiring of product
damaged
Motor protector has activated
Height of cut too low
Cutting blade blunt
Possible clogging
Blade fitted upside down
Height of cut too low
Grass too high
Grass wet or damp
Grass is dense
An additional battery can be purchased
from an authorised customer service agent.
Cutting blade obstructed
Blade nut/bolt loose
Blade nut/bolt loose
Cutting blade damaged
Battery contacts contaminated
The battery is defective, due to a
disconnection in the battery
Mains plug of battery charger not
plugged in (properly)
Socket outlet, mains cable or battery
charger defective
Corrective Action
Remove the isolator key:
Check underneath the garden
product and clear out as necessary
(always wear gardening gloves)
Charge the battery
Insert the battery
Increase height of cut and tilt
product to reduce starting
load
Allow motor to cool and increase
height of cut
Allow to cool/warm
Fit correctly
Hold On/Off switch for 1 – 3 secs
to start motor
Charge the battery
Fit correctly
Insert the battery
Allow to cool/warm
Increase height of cut
Contact Service Agent
Allow motor to cool and increase
height of cut
Increase height of cut
Replace the blade
Check underneath the garden
product and clear out as necessary
(always wear gardening gloves)
Refit blade correctly
Increase height of cut and walk slower
Increase height of cut and walk slower
Wait until grass is dry and walk slower
Increase height of cut, walk slower
and cut more frequently
Contact Service Agent
Switch off product
Clear obstruction (always wear
gardening gloves)
Tighten blade nut/bolt (15 Nm)
Tighten blade nut/bolt (15 Nm)
Replace the blade
Clean the battery contacts (e.g. by
inserting and removing the battery
several times) or replace the battery
Replace the battery
Insert mains plug (fully) into the
socket outlet
Check the mains voltage and if
necessary, have the battery
charger checked by an authorized
customer service station for power
tools