Configuring A Vlan Group - Cisco Nexus 7000 Series Configuration Manual

Configuring the Catena Solution

Configuring a VLAN Group

Before You Begin
Enable the Catena solution. For details about how to enable this, see
Solution."
Procedure
Step 1
Enter global configuration mode:
switch# configure terminal
Step 2
Create a VLAN group and enter VLAN group configuration mode:
switch(config)# catena vlan-group vlan-group-name
Step 3 Assign VLAN to the configured VLAN group (repeat this step to specify all VLANs):
switch(config-vlan-group)# vlan vlan-range
Configuring a Device Group
A device group contains a list of node IP addresses. If you are creating a Layer 3 routed mode deployment
you must create a device group.
Execute this command in the CLI config mode to create or delete a device group.
Note If there are multiple nodes, then traffic is load balanced accordingly.
Before You Begin
Enable the Catena solution. For details about how to enable this, see
Solution."
Procedure
Step 1 Enter global configuration mode:
switch# configure terminal
Step 2 Create a device group and enter device-group configuration mode:
switch(config)# catena device-group device-group-name
Step 3 Assign nodes to the configured device group:
switch(config-device-group)# node {ip ipv4-address | IPv6 ipv6-address}
Cisco Nexus 7000 Series Switches Configuration Guide: The Catena Solution
Configuring a VLAN Group
"Enabling or Disabling the Catena
"Enabling or Disabling the Catena
9