Emerson INDULGE SERIES Installation, Care & Use Manual page 3

COMPONENTS IN THIS PACKAGE
F-HC3300
F-H3300
F-HC2200 F-GN2200
F-HC2215 F-GN2215
F-HC1100 F-GN1100
Plug (1)
Y-Quick Connector Filter Head
3/8" Tubes (2)
Brass Nut/Ferrule/
SST-FLTR
Tube Insert
4
Brass Seat
(HC3300, H3300)
Rubber O-Ring Hex Nut
Semi-circular Hex Tool
Mounting Plate
Snap-Connect
Fitting (3 pieces)
Filter Cartridge
6" Filter
Discharge Tube
3/4" Screws (4)
If installing BOTH new faucet and new tank, skip to page 6.
IF INSTALLING ONLY NEW FAUCET
A
Release
Tab
1/4" 7/16" 5/16"
blue white clear
Property Damage: Unplug tank
before disconnecting tubing.
IF INSTALLING ONLY NEW TANK
A
Make note of
orientation
of ferrule
Property Damage: Do not pinch or break copper
tubing. Do not distort the last 1 inch of tubing.
B
Blue Tube
Check
orientation
of ferrule
Property Damage:
Do not over tighten brass nut.
Turn off water supply.
Remove tubes from tank: At tank
top, depress gray release tab into
quick-connect fitting securing blue
or copper 1/4" tube and gently pull
line out of fitting. Pull white 7/16"
tube and clear 5/16" tube off fittings.
Remove existing faucet and continue
to page 6.
Turn off water supply.
At tank top, depress release ring or
gray release tab into quick-connect
fitting securing blue or copper 1/4"
tube and gently pull line off tank
fitting. Pull white 7/16" tube and
clear 5/16" tube off fittings.
If not already equipped, the included
snap-connect fitting must be installed.
To install snap-connect fitting,
unscrew brass mounting nut and
remove snap-connect fitting, brass
ferrule and nut.
Slide brass nut and plastic ferrule
onto the 1/4" blue or copper tube
running from the faucet.
Insert blue or copper tube into snap-
connect fitting and tighten brass nut
with a wrench, 1 to 2 turns clockwise.
You may elect to use existing tank
mounting bracket.
Skip to Page 9, Steps 3-4 for
complete installation instructions.
5