If you experience any of the following
difficulties while using the player, use this
troubleshooting guide to help remedy the
problem before requesting repairs. Should
any problem persist, consult your nearest
There is no picture or the picture is not
, Check that all the connecting cables are
securely connected (page 10).
, Switch the input selector on your TV to
display the signal from the player.
, Reset the video output resolution to the
lowest resolution by pressing x on the
player for more than 10 seconds.
, For HDMI connections, try the following:
Turn the player off and on again.
the connected equipment off and on again.
Disconnect and then reconnect the HDMI
, The HDMI OUT jack is connected to a DVI
device that does not support copyright
, For HDMI connections, check the "Output
Video Format" settings in the "Screen
Settings" setup (page 19).
, When the analogue signals are also output,
set "BD/DVD-ROM 1080/24p Output" to
"Off" in the "Screen Settings" setup
, For BD-ROMs, check the "BD/DVD-ROM
1080/24p Output" setting in the "Screen
Settings" setup (page 20).
The display language on the screen
switches automatically when connected to
the HDMI OUT jack.
, When "Control for HDMI" is set to "On"
(page 23), the display language on the
screen automatically switches according to
the language setting of the connected TV (if
you change the setting on your TV, etc.).