Initial Check For Connection; Understanding The Led Indications - Siemens Apogee P1 Technical Manual

6

Initial Check for Connection

Understanding the LED Indications

With the correct connections to the active
APOGEE Controller, the MODULE LED
will be ON continuously and the
NETWORK LED will indicate the IDLE state
with a flash.
HVAC10 Size 1
6053 Technology Box
HEALTH
NETWORK
HINT:
The general rule for LED indications is
"ON IS GOOD, OFF IS BAD"
Health and Run LEDs
HVAC10 Size 1 (6053) Technology Box
These LEDs reproduce the indications of the LEDs on the HVAC10 drive that are hidden when
the Technology Box is fitted.
HVAC10 Size 2 & 3 (6055) Technology Box
The board does not have its own Health or Run LEDs. The LEDs are either on the Operator
Station or blank cover.
Module LED
This indicates the set-up state of the Technology Box. The states indicated are those produced
by the FAULT parameter of the TEC OPTION function block.
Module LED Indication
OFF
SHORT FLASH
FLASH
LONG FLASH
ON
ON
FLASH
RUN
MODULE
NETWORK
Figure 5 Technology Option LEDs
FAULT Parameter Indication
SELF TEST
HARDWARE
TYPE MISMATCH
PARAMETER
NONE
MODULE LED
NETWORK LED
HVAC10 Size 2 & 3
6055 Technology Box
PLG1 SW1
TB1
Description
Initialising
Hardware fault
Wrong type or disabled
Set-up fault, parameter
values out-of-range
Valid set-up, ready for
external communications
Siemens APOGEE P1 Communications Interface
MODULE