Subscribe to Our Youtube Channel
Related Manuals for Kraus FUS-13901
Summary of Contents for Kraus FUS-13901
- Page 1 I N S TA L L AT I O N MA N UA L Aquila Single Lever Basin Faucet FUS-13901 www.kraususa.com I toll free: 1.800.775.0703 I © 2014-2015 Kraus USA Inc.
- Page 2 Thank you for purchasing Kraus We would like to take this opportunity to thank you for your business with Kraus USA. It is our sincere hope that you are completely satisfied with your experience. We welcome any questions or comments you may have, and will be glad to assist you in the future.
-
Page 3: Prior To Installation
∅ Prior to Installation: • Make sure you have all necessary parts by checking the diagram and parts list. If any part is missing or damaged, please contact Kraus Customer Service at 800-775- 0703 for a replacement 1 1/4-18UNF-2A •... - Page 4 FUS-13901 Diagram and Parts List A. Faucet Body B. Base Metal Ring C. Base O-Ring D. Rubber O-Washer E. Metal U-Washer F. Mounting Screws G. Mounting Nuts H. Hot & Cold Waterlines I. Aerator Assembly I 1. Aerator Washer I 2. Aerator I 3.
- Page 5 Faucet Dimensions...
- Page 6 Lift Rod Drain Diagram and Parts List a. Waste Stopper b. Drain c. Rubber Washer d. Concave Washer e. Plastic Washer f. Mounting Nut g. Tailpipe Washer h. Tailpipe i. Top Hat Washer j. Drain Off Pole k. Washer l. Retaining Nut m.
- Page 7 Lift Rod Drain Dimensions...
- Page 8 Step 1: Install mounting hardware and waterlines Remove faucet, mounting hardware, and waterlines from the box. Remove mounting nuts (G) from mounting screws (F). Place faucet body (A) on a soft cloth, spout facing up. Secure hot & cold waterlines (H) at the base of the faucet (HAND- TIGHTEN ONLY) A.
- Page 9 Step 3: Secure faucet Install rubber O-washer (D) and metal U-washer (E), over waterlines (H) and mounting screws (F), from underneath the countertop or sink. Attach mounting nuts (G) to mounting screws (F) and tighten with adjustable wrench or 10mm wrench until snug Step 4: Connect waterlines to main valve Thread hot &...
-
Page 10: Step 5: Install Drain
Step 5: Install Drain • Remove waste stopper (a) from drain (b). Remove tail pipe (h), mounting nut (f ), plastic washer (e), and concave washer (d) from drain (b). Remove retaining nut (l) and washer (k) from tailpipe Installer tip: Leave top hat washer (g) in tailpipe (h) •... - Page 11 Step 5: Install Drain • Insert waste stopper (a) into drain (b). Make sure slot at end of waste stopper (a) is facing the rear of the sink • Insert lift pole rod (p) through the hole in the back of the faucet body (a).
- Page 12 Step 5: Install Drain • Place one end of clip (n) on drain off pole (j). Insert drain off pole (j) through desired hole of extender rod (m). Place other end of clip (n) on drain off pole (j) Installer Tip: You may adjust the extender rod (m) to a desired height Step 6: Flush Faucet...
- Page 13 Replacement Part List - FUS-13901 1. Metal Handle 2. Set Screw 3. Cover Button 4. Cartridge Cover 5. Locking Nut 6. Cartridge 7. Aerator Washer 8. Aerator 9. Aerator Cover 10. Base Metal Ring 11. Base O-ring 12. Rubber O-Washer 13.
- Page 14 Replacement Part List - Lift Rod Drain 1. Waste Stopper 2. Drain 3. Rubber Washer 4. Concave Washer 5. Plastic Washer 6. Mounting Nut 7. Tailpipe Washer 8. Tailpipe 9. Top Hat Washer 10. Drain Off Pole 11. Washer 12. Retaining Nut 13.
-
Page 15: Troubleshooting
Trouble - Shooting If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps: P R O B L E M C A U S E A C T I O N Leakage under the Locking nut (5) has Remove cover button... -
Page 16: Care And Maintenance
Push Left Open Hot Water Care & Maintenance *To keep the product clean & shining, follow the steps below: Rinse with clean water & dry with a soft cloth Do not clean with soaps, acid, polish, abrasives, or harsh cleaners Do not use cloth with a coarse surface Unscrew the aerator and clean when necessary *This installation manual is subject to change without further notice. - Page 17 If Kraus is unable to provide a replacement and repair is not practical or cannot be made in timely fashion, Kraus may elect to refund the purchase price in exchange for the return of the product.
- Page 18 NON-APPLICABILITY OF THIS WARRANTY By the purchase and use of our products, you agree that Kraus is not liable for incidental, consequential or special damages associated with the return, replacement, installation or use of your product. This includes freight costs,...
- Page 19 www.kraususa.com...
- Page 20 www.kraususa.com...
Need help?
Do you have a question about the FUS-13901 and is the answer not in the manual?
Questions and answers