Adding A Device To Polling Table - Honeywell Intelliguard 9000 Programmer's Manual

INTELLIGUARD 9000
1. Press Alt+F2 to display the Polling Table. See Fig. 8.
Fig. 8. Polling Table.
The Polling Table contains the following fields:
No. (Number) The device number.
Ref. (Reference) The device reference number.
Device The device name.
Addr (Address) The device address.
Com The communication port number.
Serial # (Number) The device serial number if applicable.
Location The device location.
Area Msk The assigned CC-2 or KID area number. If a device is
assigned to cover more than one area, do not separate the
area numbers with commas. For example, if a device applies
to areas one and two, type 12 in the Area Msk field.
NOTE: The addressing of each device is set either by dip switch or serial number.
The address entered into the Addr field must be unique for each type of
device.
NOTE: Honeywell recommends entering the addresses in sequential order.
NOTE: Addresses permitted for device types with serial numbers are:
KID 0 to 7.
MOM 1 to 61.
BIC-2 0 to 61.
BIC-6 0 to 61.
HEDS-IV 0 to 61.
NOTE: The I9000 CU considers the BIC-2, BIC-6, and HEDS-IV all to be the same
type of device
15

Adding a Device to Polling Table

74-3046