Empty the fuel system by running the engine at idle speed until the engine stalls
(If left in for a long time, the fuel will break down and clog the fuel system.).
Remove the spark plugs and spray fogging oil directly into each cylinder. Push
the starter button for a few seconds to coat the cylinder walls. Install the spark
An air/oil mist may be forcibly ejected from the spark plug holes and could
get into your eyes. Do not lean over the engine when performing this pro-
cedure. If you do get oil in your eyes, wash them immediately with liberal
amounts of clean, fresh water and consult a physician as soon as possi-
Reduce tire pressure by about 20%.
Set the motorcycle on a box or stand so that both wheels are raised off the
ground (If this cannot be done, put boards under the front and rear wheels to
keep dampness away from the tire rubber.).
Spray oil on all unpainted metal surfaces to prevent rusting. Avoid getting oil on
rubber parts or in the brakes.
Lubricate all the cables.
Remove the battery, and store it where it will not be exposed to direct sunlight,
moisture, or freezing temperatures. During storage it should be given a slow