Download  Print this page

Kawasaki VN1700 Voyager Custom ABS 2010 Owner's Manual Page 184

Hide thumbs

Advertisement

182
MAINTENANCE AND ADJUSTMENT
Take the battery out of the battery
case.
Clean the battery using a solution of
baking soda and water. Be sure that
the cable connections are clean.
Battery Installation
Place the battery in the battery case.
Connect the (+) cable into the (+) ter-
minal, and then tighten the (+) termi-
nal bolt into the (+) terminal.
Connect the (–) cable into the (–) ter-
minal, and then tighten the (–) termi-
nal bolt into the (–) terminal.
NOTICE
Installing the (−) cable to the (+)
terminal of the battery or the (+)
cable to the (−) terminal of the
battery can seriously damage the
electrical system.
NOTE
When installing the battery, the
speedometer needle may momenta-
ry point to the last reading. If the bat-
tery is disconnected while the meter
needle is moving, the needle will
stop on its way, but will normally re-
turn when the battery is connected
again.
Put a light coat of grease on the ter-
minals to prevent corrosion.
Cover the (+) terminal with the red
cap.
Install the battery case cover, and
tighten
the
battery
screws.
Reinstall the removed parts.
case
cover

Advertisement

Table of Contents

This manual is also suitable for:

Vn1700 voyager custom abs 2013

Comments to this Manuals

Symbols: 0
Latest comments: