14
Setting up the sewing computer
Inserting the bobbin
Insert the bobbin
Insert the bobbin so that the
thread runs clockwise.
Changing the needle
Pull the thread counter clock-
wise into the slot.
Removing the needle
raise the needle
•
turn power switch to «0»
•
lower the presser foot
•
loosen the needle clamp screw
•
pull the needle down to remove
•
Inserting the needle
flat side of needle to the back
•
insert the needle as far as it will go
•
tighten the needle clamp screw
•
030529.52.04_0303_a135 a145_EN
Pull the thread to the left
under the spring until ...
... it lies in the T-shaped slit at
the end of the spring.
The bobbin must turn clock-
wise when thread is pulled.
Refer to the safety
instruction!