Setting the Access Point Manually
Check SSID or Network Key for a Wireless LAN
• Check the label on the Wireless LAN router.
Write down the name of SSID and network key
displayed in step 1. When multiple access points are
displayed, write all SSIDs that are displayed.
It is sometimes written as name of network, or name of
access point. If there are multiple SSIDs, please write down
It is sometimes written as PIN, WEP key, WPA/WPA2
passphrase, PSK or preshared key.
Tap <Menu> in the Home Screen.
Tap <Network Settings>.
If a screen for entering a System Manager ID and PIN is
displayed, enter the System Manager ID and PIN, tap
<Apply>, and press
Tap <Wireless LAN Settings>.
Read the message that is displayed, and tap <OK>.
Tap <SSID Settings>.
Tap <Select Access Point>.
Select Access Point
Select a wireless LAN router.
If multiple matched SSIDs are displayed, select the ID that
is listed first (the one with the strongest signal).
Enter the network key that you have written
Enter the network key using the numeric keys, and tap
WEP Key (5-26 Characters)
After the <Connected.> screen is displayed, wait
until the Wi-Fi indicator stops blinking and turns
Wait approximately 2 minutes after the
IP address is set during this period of time.
When an error message appears:
Tap <Close> to close the screen, check whether or not
the network key is correct, and then retry the settings.
If the access point cannot be detected even after
retrying, see the following.
e-Manual "When an Error Message Appears"
To set IP address manually:
e-Manual "Connecting to a Wireless LAN"