Installation Of The Appliance - Electrolux EVE614 User Manual

INSTALLATION OF THE APPLIANCE

WARNING
The appliance must not be installed behind a
decorative door in order to avoid overheating.
To avoid any potential hazard, you must follow
our instructions when you install your appliance.
Failure to install the appliance correctly could
invalidate any warranty or liability claims and lead
to prosecution.
Use an authorised person
As stated in the local municipal building codes and other
relevant statutory regulations:
• Wiring connections must be in accordance with AS/
NZS 3000 Wiring Rules and any particular conditions
of the local authority.
• Refer to data plate for rating information. The data
plate is positioned behind the bottom of the oven door.
• For appliances with open cooking surfaces, a
disconnect functional switch should be provided near
the appliance in an accessible position. Refer to
AS/NZS 3000 clause 4.7.1
• Wiring should be protected against mechanical failure.
Refer to AS/NZS3000 clauses 3.3.2.6, 3.9, 3.10
• A means of disconnection with a contact separation
of at least 3mm must be supplied in the fixed wiring.
• This appliance must be connected with cable of 75°C
rating minimum.
• This product has passed the insulation resistance
test after manufacture. If the resistance reading is low
at installation, it is probably caused by moisture from
the atmosphere being absorbed by the elements
after the appliance has been produced. (pass at
0.01MΩ AS/NZS 3000 Wiring Rules Clause 8.3.6.2).
WARNING
This appliance must be properly earthed.
• Do not lift the appliance by the door handles.
• Prepare the cupboard opening to match your
appliance measurements. (See diagrams)
• Slide appliance into the cupboard, ensuring that the
supply cable (where fitted) does not kink.
• To prevent tipping, use the screws supplied to
secure your appliance into the cupboard by fastening
through the 4 holes to the front panel.
• Where the appliance is built into a cabinet, the
cabinet must be capable of withstanding 70°C.
Installation into low temperature tolerant cabinetry
(e.g. Vinyl coated) may result in deterioration of the
low temperature coating by discolouring or bubbling.
• If the appliance is to be installed adjacent to vinyl
wrapped surfaces, use an installation kit available
from the vinyl-wrap supplier.
• Electrolux Home Products cannot accept
responsibility for damage caused by installation into
low temperature tolerant cabinets.
• After installation, test and ensure that the appliance
operates correctly before handing it over to the customer.
NOTE: If a powerpoint is fitted it must be accessible with
the appliance installed, as the plug must be accessible
after installation.
Cabinet construction for your appliance
For the best integration within a kitchen, install this appliance
in a standard 600mm wide cupboard that gives a flush fit
(Figure A) with the surrounding cupboard fronts. Non-pyrolytic
appliances can also be installed using a proud fit (Figure B).
IMPORTANT
For all Pyrolitic clean models, the oven must be
installed as a flush fit (Figure A) to the surrounding
cupboards and the "infill panel" MUST not exceed
100mm in length. This ensures a 16mm gap is
maintained between the cabinet and side of the
appliance to prevent the cupboard overheating.
Figure A – Flush Fit
16mm
Infill panel
Oven
Cupboard
door
Figure B – Proud Fit
16mm
Infill
panel
Cupboard
Oven
door
600mm
NOTE: Your appliance must be mounted on a flat
horizontal surface for the full width and depth of
the product
568mm
100mm max
for pyro oven
20mm
600mm
568mm
61