Troubleshooting - Electrolux EQT4520BOG User Manual

Teppan yaki grill plate
Hide thumbs Also See for EQT4520BOG:
Table of Contents

Advertisement

Available languages

Available languages

TROUBLESHOOTING

You cannot activate the
appliance or operate it.
An acoustic signal sounds
and the appliance deacti-
vates.
An acoustic signal sounds
when the appliance is de-
activated.
The appliance deacti-
vates.
The residual heat indicator
does not come on.
There is no signal when
you touch the panel sen-
sor fields.
comes on
comes on
and number come on.
If you tried the above solutions and cannot
repair the problem, speak to your dealer or
the Customer Care Department. Give the
data from the rating plate, three-digit-letter
code for the glass ceramic (it is in the cor-
ner of the cooking surface) and an error
message that comes on.
Problem
Possible cause
You touched 2 or more
sensor fields at the same
time.
There is water or fat
stains on the control pan-
el.
You put something on one
or more sensor fields.
You put something on the
sensor field
.
The cooking zone is not
hot because it operated
only for a short time.
The signals are deactiva-
ted.
The Automatic Switch Off
operates.
The Child Safety Device or
the Lock function oper-
ates.
There is an error in the ap-
pliance.
If you operated the appliance incorrectly,
the servicing by a customer service techni-
cian or dealer will not be free of charge,
even during the warranty period. The in-
structions about the customer service and
conditions of guarantee are in the guaran-
tee booklet.
ENGLISH
Remedy
Activate the appliance
again and set the heat set-
ting in less than 7 sec-
onds.
Touch only one sensor
field.
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the cooking zone oper-
ated sufficiently long to be
hot, speak to the service
centre.
Activate the signals (refer
to "OffSound control").
Deactivate the appliance
and activate it again.
Refer to the chapter "Op-
erating instructions".
Disconnect the fuse from
the electrical system of the
house in order to discon-
nect the appliance from
the electrical supply for
some time. Connect it
again. If
comes on
again, speak to the service
centre.
75

Advertisement

Table of Contents
loading

Subscribe to Our Youtube Channel

Table of Contents