Snapper 1691827 Installation Instructions

Section A. General
This kit provides an add-on light and required
a l t e r n a t o r f o r c o m p a c t a n d l a r g e f r a m e
snowthrowers with Tecumseh engines. Kit can be
installed on snowthrowers that are equipped with
cabs (hard or soft). See the appropriate section for
installation instructions:
Snowthrower
Section
C o m p a c t No Cab/Soft Cab
Section C.
Large-Frame
Section D.
Section E. Large-Frame
Section B. Kit Parts
DESCRIPTION
Alternator
B.
Self-Tapping Screw, :&I@"**
C. AC Ughtlng Connector
D. Spacer'
E. Tube
F.
Alternator Shaft, 3""
Alternator Shafl, 3-M"'
G.
H. Plastic Tie'
"7, 6, 10 HP Models
Figure 1.
Application
No Cab/Soft Cab
Hard Cab
QTY.
1
1704652 3
1704663 3
1704647 1
1704646 1
1704649 1
1704641 1
1704642 1
1704644 1
2
925094
930222 1
INSTALLATION
INSTRUCTIONS : ~ ~ ,
SNOWTHROWER
Section C. Compact Snowthrower With Sofi Cab/
Without Cab.
1. Drill a 13/&Y hole, 5/8" from bottom and
centered (approx. 8-i/2" from either end) on the
crossmember as shown in figure 2.
AD-815
2. Install light with capsorew, lockwasher, and nut
(lockwasher and nut towards rear).
3. Install alternator as provided in the Tecumseh
Installation Instructions.
alternator shaft (F, figure 1) and self-tapping
screws (B).
4. Install clip and plastic ties as shown in figure 3.
This will prevent wire harness from interfering
with recoil starter.
HEADLIGHT KIT
MFG. NO. 1691827
Use the appropriate
I I
F O R M 1704651-02