Advertisement
Reimage the Firepower Threat Defense Device
CAUTION:
You have selected IPv6 stateless autoconfiguration, which assigns a global address
based on network prefix and a device identifier. Although this address is unlikely
to change, if it does change, the system will stop functioning correctly.
We suggest you use static addressing instead.
Apply the changes?(y,n) [Y]: y
Configuration saved successfully!
Applying...
Restarting network services...
Done.
Press ENTER to continue...
firepower-boot>
Step 8
Download the Firepower Threat Defense system software install package. This step shows an HTTP installation.
system install [noconfirm] url
Include the noconfirm option if you do not want to respond to confirmation messages.
Example:
> system install noconfirm http://10.86.118.21/ftd-6.0.1-949.pkg
You are prompted to erase the internal flash drive. Enter y.
######################## WARNING ############################
# The content of disk0: will be erased during installation! #
#############################################################
Do you want to continue? [y/N] y
The installation process erases the flash drive and downloads the system image. You are prompted to continue
with the installation. Enter y.
Erasing disk0 ...
Verifying
Downloading
Extracting
Package Detail
Description: Cisco ASA-NGFW 6.3.0 System Install
Requires reboot: Yes
Do you want to continue with upgrade? [y]: y
When the installation finishes, press Enter to reboot the device.
Warning: Please do not interrupt the process or turn off the system.
Doing so might leave system in unusable state.
Starting upgrade process ...
Populating new system image
Reboot is required to complete the upgrade. Press 'Enter' to reboot the system.
The reboot takes upwards of 30 minutes, and could take much longer. Upon reboot, you will be in the Firepower
Threat Defense CLI.
Cisco ASA and Firepower Threat Defense Reimage Guide
28
Cisco ASA and Firepower Threat Defense Reimage Guide
Advertisement
