Download Print this page

Cisco ASA 55 Series Software Manual page 15

Threat defense reimage guide

Advertisement

Cisco ASA and Firepower Threat Defense Reimage Guide
sync
tftpdnld
The ASA image downloads and boots up to the CLI.
See the following information:
• interface—(ASA 5512-X, 5515-X, 5525-X, 5545-X, and 5555-X only) Specifies the interface ID. Other
models always use the Management 1/1 interface.
• set—Shows the network settings. You can also use the ping command to verify connectivity to the server.
• sync—Saves the network settings.
• tftpdnld—Loads the boot image..
Example:
Example for the ASA 5555-X:
rommon 2 > interface gigabitethernet0/0
rommon 3 > address 10.86.118.4
rommon 4 > netmask 255.255.255.0
rommon 5 > server 10.86.118.21
rommon 6 > gateway 10.86.118.1
rommon 7 > file asalatest-smp-k8.bin
rommon 8 > set
ROMMON Variable Settings:
ADDRESS=10.86.118.3
NETMASK=255.255.255.0
SERVER=10.86.118.21
GATEWAY=10.86.118.21
PORT=GigabitEthernet0/0
VLAN=untagged
IMAGE=asalatest-smp-k8.bin
CONFIG=
LINKTIMEOUT=20
PKTTIMEOUT=4
RETRY=20
rommon 9 > sync
Updating NVRAM Parameters...
rommon 10 > tftpdnld
Example for the ASA 5506-X:
rommon 2 > address 10.86.118.4
rommon 3 > netmask 255.255.255.0
rommon 4 > server 10.86.118.21
rommon 5 > gateway 10.86.118.21
rommon 6 > file asalatest-lfbff-k8.SPA
rommon 7 > set
ROMMON Variable Settings:
ADDRESS=10.86.118.3
NETMASK=255.255.255.0
SERVER=10.86.118.21
GATEWAY=10.86.118.21
VLAN=untagged
Reimage from Firepower Threat Defense to ASA
Cisco ASA and Firepower Threat Defense Reimage Guide
15

Advertisement

loading