Paper Jam, Skew And Staple Detection Processing - Canon imageFORMULA DR-G2140 User Manual

Paper Jam, Skew and Staple Detection Processing

When a paper jam, skew, or staple is detected, any documents
remaining in the Eject Tray and scanner must be removed.
CAUTION
• Be careful removing any documents remaining inside the scanner.
Otherwise, documents could be damaged or unexpected injury
from paper cuts may occur.
• Remove all documents remaining inside the scanner. Any torn
paper remaining inside may cause paper jams or breakdowns.
1
Remove any documents that have been left in the Eject
Tray.
2
Open the upper unit smoothly.
CAUTION
When opening and closing the upper unit, be careful not to get
your fingers caught, as this may result in personal injury.
3
If any documents remain inside the scanner, remove
them.
IMPORTANT
• With the upper unit slightly opened, remove any document that
is partially ejected on the Eject Tray.
• Open the upper unit to the point where it stops, and remove the
document remaining inside the scanner.
(See p. 137)
4
Smoothly close the upper unit. Further, press both ends
of the upper unit to verify that it is securely closed.
p. 138)
5
Check the last saved image, and try scanning again.
Return the document removed from inside the scanner to the top
of the stack in the input tray, and press the Start key to resume
scanning.
IMPORTANT
• Scanned images may not be saved even for documents ejected
onto the Eject Tray. Be sure to check the last scanned image
saved before scanning again.
• If a skewed document was detected, reload it straightly and
scan again.
• If a staple was detected, remove the staple, reload the
document, and scan again.
168
(See