2Checking The Connection - Canon BW UFRII LT PRINTER KIT-J2 Installation Procedure

Chapter 1
- 4 TP screws (3x8) [2]
[2]
Points to Note When Attaching the LAN Cover
A grounding wire is fitted to the IP machine's IP PCB
and IP cover. When attaching the LAN cover, be sure
to remove the screw [1] from the wire, and tighten the
screw over both the wire and the LAN cover [2].
When mounting the LAN cover [1], take care so that
the grounding plate [3] will not be bent by the LAN
board [2].
Also, after mounting the cover, check to be sure that
the grounding plate is in firm contact with the LAN
board.
4
[2]
[1]
F-1-7
[2]
F-1-8
[3]
8) Put back the machine's rear cover you removed in
step 2).
9) Connect the user's LAN cable to the machine.
F-1-10
10) Connect the power plug to the power outlet, and
turn on the main power switch.
1.2.2 Checking the Con-
nection
At the end of the work, go through the following steps
to make sure that the machine properly recognizes the
presence of the unit:
1) Start service mode.
[2]
[1]
F-1-9
0010-7517