Acer C200 Quick Start Manual page 2

Intrduction
• Product Overview
10 11
6
7 8 9
5
4
• Output power state
Power On
Power
adaptor
DC 5V OUT 5V
MHL 5V
HDMI X
Note: When MHL is connected to the projector, the DC 5V
OUT will not work.
• Battery discharge time under Display mode
#1
HDMI
Battery life #2
(Hour)
Note:
#1
1920x1080@60Hz
#2
DC5V output off
Reminder & Maintenance
1. This product can be installed in the desktop only,
otherwise lamp life could decrease dramatically.
2. Keep the power more than 30% always for better
cell life.
3. Fully recharge the power bank at least every 3
months.
4. Protect from moisture and corrosive materials.
5. The projector will automatically shutdown when
there is no signal input after 15 minutes.
6. The projector will automatically enter Eco mode for
power saving power if there is no any signal input
after 5 minutes.
7. With fast charging technology, the battery power
level will increase from 5% to 80% in approximately
3 hours and 30 minutes, and to 100% in
approximately 4 hours and 45 minutes.
8. The battery capacity will be decreased by longer
time and more recycling times.
12
13 14 15 16
19 18
1
Power Off
Power Power Power
Battery adaptor Battery
5V 5V
5V X
X X
Eco Standard Bright
O O
4.5 3
# Description
1 Projection lens
17
2 Focus ring
3 Air inlet
4 Tilt adjusting wheels
/ Flipping handle
5 Air outlet
6 Direction keys
7 Volume Down
8 MODE/Confirmation 18 Battery Indicator LED
Volume UP
9
2
10 MENU/Exit
3
• Power
• Compatibility modes
A. HDMI-PC
5V
SVGA/XGA/WXGA/1080p
X
B. HDMI-Video (MHL)
X
480i/480p/720p/1080i/1080p*
576i/576p/720p/1080i/1080p*
1080p
MHL
Note: *
O
• LED indicator / Message
2
Battery status
POWER_LED
Battery level
70%~100%
40%~70%
5%~40%
#1
< 5%
#2
Fan fail
Projector
overheated
Battery
Overheat
Note:
#1
The projector will automatically shutdown after event.
#2
The projector will automatically shutdown before event.
#
11 Headphone
12 Reset hole
13 HDMI/MHL connector
14 5V DC output
connector
15 DC input
16 Power button
17 Kensington
port
19 Power/Charge
Indicator LED
Power On Long press >1s
Power Off Short press <1s twice
Power bank Short press <1s
On /Off under battery mode
Resolution
Resolution
is not supported.
Charging
Red
BATT_LED
Green
Orange
Red
Red (flashing)
(0.5s On/0.5s Off)
Red (flashing)
(1s On/0.5s Off)
Red (flashing)
#2
(0.5s On/1s Off)
Orange (flashing)
English
Description
TM
lock
Refresh rate (Hz)
60
Refresh rate (Hz)
60
50
24
Completed
Blue
Message
The projector will
automatically
shutdown after:
(seconds)
10s
30s
30s
--