Download Print this page

Honeywell EGPWS MK V Pilot's Manual page 101

Enhanced ground proximity warning system
Hide thumbs

Advertisement

Table of Contents
Mark V and Mark VII EGPWS Pilot's Guide
"Flap Monitor INOP"
Displayed Message
RAAS OK FT
(green)
RAAS OK M
(green)
RAAS N/AVBL
(amber)
RAAS NA X
(amber)
RAAS INH
(amber)
RAAS RTO
(green)
RAAS INOP
(amber)
060-4241-000
Rev H, August 2011
Take-off Flap Configuration Monitor is enabled but the
function is inoperative. Annunciated on ground during
Level 1 Self-Test.
RAAS status can also be displayed on the Terrain
Display. This is active only when the aircraft is on the
ground. If the INOP, Inhibit or Not available conditions
exist, the status is immediately shown on the Terrain
display and can be cleared by a range change. For all
other status messages, the procedure requires the flight
crew to select the terrain display followed by a change
in the displayed range (to a higher or lower range).
RAAS status is annunciated for two sweeps of the
Terrain Display. This feature is available on all aircraft,
but is primarily intended for those aircraft where the
flight crew does not perform an EGPWS self-test. The
displayed status messages are as follows.
RAAS Status Display Messages
RAAS software enabled, functioning, has good position
information, and is at a validated airport. Distances
annunciated in feet.
RAAS software enabled, functioning, has good position
information, and is at a validated airport. Distances
annunciated in metres.
RAAS software enabled, but the system either has no
position information or the accuracy of the position
information is insufficient to allow RAAS to function.
RAAS software enabled, but the location airport has
not been validated for RAAS in the EGPWS Terrain
Database. X = the location airport designator. For
example RAAS-NA-KSBP for San Luis Obispo Co.
Regional Airport. Added in -230-230 software version.
RAAS software enabled, but the advisories have been
inhibited with the activation of an external discrete.
RAAS software enabled and functioning, but RAAS has
detected a Rejected Take-Off condition. To clear this
message, the aircraft must be taxied off the runway
area.
RAAS software enabled but function is inoperative.
Conditions
®
Smart Runway
95

Hide quick links:

Advertisement

Table of Contents
loading

  Also See for Honeywell EGPWS MK V

  Related Manuals for Honeywell EGPWS MK V

This manual is also suitable for:

Egpws mk vii