Troubleshooting - Panasonic VDR-D150GC Operating Instructions Manual

LSQT1049(ENG).book 219 ページ ２００５年１２月２０日 火曜日 午後６時４５分

Troubleshooting

Problem
This unit cannot be
turned on.
This unit is turned off
automatically.
This unit does not stay
on long enough.
Battery runs down
quickly.
This unit cannot be
operated though
powered up.
This unit does not
operate normally.
The screen has changed
suddenly.
Check points
≥ Is the battery fully charged?
# Charge the battery using the AC adaptor. (l 132)
≥ If you do not use the unit for approximately 5 minutes, the
power is automatically turned off to conserve the battery
charge. To resume recording, turn the power back on.
The power will not turn off automatically when the power
save function (l 212) is set to [OFF].
≥ Is the battery low?
# If the remaining battery power indication is flashing or the
message "LOW BATTERY." is displayed, the battery has run
down. Charge the battery. (l 132)
≥ Is the battery fully charged?
# Charge it with the AC adaptor. (l 132)
≥ Are you using the battery in an extremely cold place?
# The battery is affected by ambient temperature. In cold
places, the operating time of the battery becomes shorter.
≥ Has the battery worn out?
# The battery has a limited life. If the operating time is still too
short even after the battery is fully charged, the battery has
worn out and can no longer be used.
≥ Press the RESET button. (l 222) If normal conditions are
not restored yet, remove the battery or AC adaptor, wait
about 1 minute and then reconnect the battery or AC
adaptor. Then about 1 minute later, turn on the power
again. (Conducting the above operation when the access
lamp is on may destroy the data on the disc or card.)
≥ Has the demonstration started?
# If you set [DEMO MODE] to [ON] without inserting a disc or a
card in disc recording mode or card recording mode, the unit
is automatically set to the demonstration mode for
introducing its functions. Normally this should be set to
[OFF]. Press the MENU button, then select [SETUP] #
[DEMO MODE] # [OFF] and press the joystick.
Troubleshooting
219
LSQT1049