Troubleshooting; Advanced Setting; Switch Operation Chart - Panasonic CZ-TAW1 Operating Instructions Manual

Troubleshooting

■
When you cannot connect in the Wireless
mode
→ Check the strength of the wireless
signal.
How to check the strength of the wireless signal (press the Check switch)
→You can check the strength of the wireless signal by checking if the
Link LED is lighting or blinking.
<
Wireless signal>
When there is no problem with the wireless signal but the Status
LED does not light
→ Check the router connections.
* If the wireless signal strength is BAD or worse, connect using the
Ethernet mode.
■
When you cannot connect in the Ethernet mode
• When the Status LED does not light
→Check the LAN cable connections.
Check the router connections.

Advanced Setting

■
When you want to set the IP of the wired LAN manually
1) Start the IP setting tool on the attached CD‑ROM and save the settings
to a USB memory device.
2) Attach the USB memory device with the saved settings to the adaptor
and press and hold the WPS switch for 10 seconds.
3) The Link LED lights when the settings are complete.
■
When you want to set the SSID of the wireless LAN manually
1) Start the SSID setting tool on the attached CD‑ROM and save the
settings to a USB memory device.
2) Detach the USB memory device and then attach to the adaptor and
press and hold the WPS switch for 10 seconds.
3) The Link LED lights when the settings are complete.
Link LED
Check switch
Strength: GOOD
Strength: NORMAL
Strength: BAD
Strength: IMPOSSIBLE
7

Switch Operation Chart

WPS switch
Aim Switch operation
To switch WPS ON Press the WPS
switch.
To register a user Press the Register/
Reset switch.
To check the status of Press the Check
communications switch.
To switch between the Press the Check
Ethernet and Wireless switch for at least
modes 10 seconds.
To reset the software Press the Register/
Reset switch for at
least 10 seconds.
To specify the SSID Press the WPS
manually. switch for at least
(in Wireless mode) 10 seconds.
To specify the IP
manually.
(in Ethernet mode)
To initialize the adaptor Simultaneously
press the WPS
switch and the
Check switch for at
least 10 seconds.
Register/Reset switch
Check switch
Remarks
This is only effective when
Wireless mode is on.
This is only effective when
communications have been
established.
LEDs are displayed according
to the connection status.
The settings for each mode
are maintained even if you
change the mode.
This starts the process for
the software to reset itself.
When resetting, checks are
made for the latest firmware,
and this is updated if a new
version is available.
Connection is by WPS/
DHCP if there are no
settings to load from the
USB memory device.
This restores the adaptor's
settings to the factory defaults.