Beep Codes; Error Messages; Diagnostic Lights - Dell Precision 350 Setup And Quick Reference Manual

Beep Codes

Your computer might emit a series of beeps that identify a problem. One
possible series (code 1-3-1) consists of one beep, a burst of three beeps, and
then one beep. This series tell you that the computer encountered a
memory problem.
If a beep code is emitted, write it down and look it up under "Beep Codes"
in the User's Guide.

Error Messages

If an error occurs during start-up, a message may be displayed on the
monitor identifying the problem. See "Error Messages" in the User's Guide
for suggestions on resolving any problems.

Diagnostic Lights

To help you troubleshoot a problem, your computer is equipped with four
lights on the back panel labeled "A," "B," "C," and "D." These lights can be
yellow or green. When the computer starts normally, the lights flash. After
the computer starts, the lights remain green. If the computer malfunctions,
the color and sequence of the lights identify the problem.
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions in the System Information Guide.
Light Pattern
GYYY
Problem Description
The computer is in a
normal off condition or a
possible power failure has
occurred.
Other failure has occurred.
Suggested Resolution
Verify that the computer power cable is plugged into the
computer and a working electrical outlet. Press the power
button.
• Ensure that the cables are properly connected from
the hard drive, CD drive, and DVD drive to the
system board.
• If the problem persists, contact Dell.
Setup and Quick Re ference Guide
NOTE: If the message is
not listed, see the
documentation for either
the operating system or
the program that was
running when the message
appeared.
23