Special Accessories - AEG 7023 TK ELECTRONIC User Manual

70
Installation
1. Open loading door.
2. Unscrew hinge A from the front of the
machine and take off the loading door.
Remove cover plates B . To do this, insert
3.
a thin screwdriver into the slots as
shown in the illustration, press down-
wards slightly and pry out the cover
plates.
4. Use an appropriate tool and exert pressure to unfasten locking block C from the snap-
on fixture, take out and re-insert on the other side having rotated the block through
180°.
Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite
5.
side and screw down.
6. Re-insert cover plates B on the opposite site having first rotated them through 180°.
7. Unscrew cover plates D from the front
of the machine, rotate through 180°,
screw on the opposite side.
Unscrew door lock E , push down slightly
8.
and remove from the front of the ma-
chine.
9. Press snap-in button F in and down,
press cover down slightly and remove from front of the machine.
10. Change door lock E over to the opposite side, screw down the door interlock.
11. On the other side, insert cover F and allow snap-in button to lock into place.
12. Insert loading door and hinges into recesses on the front of the machine and screw
down.
Note regarding contact protection: The machine is only secure for operations again once
all plastic parts have been inserted.

Special accessories

• Stacking kit
These intermediate installation kits can be used to arrange the dryer and a washing
machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. The washing
machine is at the bottom and the dryer is at the top.
Read carefully the instructions supplied with the kit.
Available from your Service Force Centre or your specialist dealer
• Draining kit
Installation kit for direct draining of the condensed water into a basin, siphon, gully, etc.
The water reservoir then no longer has to be drained, it must however remain in its
intended position in the machine.
Fixed hose has to be on the suitable height from minimum of 50 cm to maximum of 1
m from floor level and cannot be looped. If possible shorten the draining hose.
Read carefully the instructions supplied with the kit.
Available from your Service Force Centre or your specialist dealer
A
C
B
A
D
E
F
E
D
B
F