Siemens SXG75 User Manual page 127

of SXG75, FUG us-en, A31008-H8900-A1-1-7619 (07.10.2005, 13:12)
right page (127)
Eject card
Eject the RS MultiMediaCard from the
phone safely without losing data
that is still being transmitted to the
card.
C
If card is still busy, confirm the error
message with
Memory assistant
Start the memory assistant
(page 25).
Phone identity
The phone identity number (IMEI) is
displayed. This information may be
useful for customer service.
F
Device check
After the last information page,
a self-test as well as the individual
test are offered. If you select
all individual tests are carried out.
Software version
To display the software version for your
phone in standby mode:
*
# 0 6 #, and select the Configuration tab.
Press to confirm request.
C
and try again later.
Switch between tabs to
display additional infor-
mation about the device.
Self
Device manager (DM)
Sessions can be initiated in different
ways.
• Manual session: You start the DM
session via this menu option.
• WAP push: Your service provider
initiates a DM session via WAP
push (page 68). You receive an
Over The Air Provisioning (OTAP)
message. The message is dis-
played. Confirm the request to
start the DM session.
The OTAP message can be protect-
ed and you may need a PIN to
open it. Contact your provider for
further information.
• Software update: The phone
checks the software status each
time it is switched on. If an update
is available a request is displayed.
Confirm the requests to start the
software update and to re-boot
your phone.
test,
Additional information
If you want to start a session the battery
must be charged at least 50%.
Settings 127