Leica Q2 Instruction Manual page 138
Hide thumbs
Also See for Q2:
- Quick start manual ,
- Instruction manual (233 pages) ,
- Instruction manual (164 pages)
Table of Contents
Advertisement
EN
The display switches off after the picture is taken/
the LCD panel goes dark after the picture is taken
Camera does not focus
Flash won't fire
The flash does not fully illuminate the object
Image does not sharpen automatically
No face detection/faces are not recognized
Camera selects incorrect object
No continuous recording available
The image on the LCD panel displays lots of noise
Image storage takes a long time
Manual white balance is unavailable
Viewfinder is out of focus
AF metering field is framed in red with activated AF;
images out of focus
138
Flash loads after picture is taken, LCD panel
deactivates during load time
Desired object part is too close to the camera
Desired object part is very far away
Object not suitable for AF
The flash cannot be used with the current settings
Flash is deactivated
The battery is flat
Pressing the shutter button while flash is still loading
Electronic shutter function is selected
Automatic bracketing or Picture series is activated
Object is outside the flash range
Flash is covered
AF is deactivated
Face is covered (sunglasses, hat, long hair, etc.)
Face takes up to little space in the picture composition Change image composition
Face is tilted or horizontal
Camera not held straight
Face is insufficiently lit
The incorrectly selected object is closer to the image
center that the main object
The incorrectly selected object is a face
The camera is overheated and the function was
temporarily disabled to protect the camera
Light enhancement function of the LCD panel in dark
surroundings
Noise Suppression is activated for long-term exposures Deactivate the function
The image object is too bright or too dark
Check the diopter setting
Focusing was unsuccessful
Wait until the flash is loaded
Select Macro mode
Exit Macro mode
Use Focus lock or select manual focus
Refer to the list of flash function-compatible settings
Select other flash mode
Charge or replace the battery
Wait until the flash is loaded
Change the setting
Select other mode
Move object into flash range
Make sure the th flash unit is not covered by your finger
or some object
Activate AF
Remove distracting objects
Keep face straight
Hold camera straight
Use flash, improve illumination
Change the image section or take picture using the
focus lock
Deactivate face detection
Allow camera to cool down
Not a fault – picture quality will not be impacted
adjust the diopter setting as needed
Try to focus again
Advertisement
Table of Contents
