Installation - Haier 1U71S2SG1FA Service Manual

7. Installation

① Before Installation <Don't discard any accessories until comp>
• Determine the way tocarry unit toinstallation place.
• Don't remove packing until unit reaches installation place.
• If unpacking is unkavoidable, protect unit properly.
② Selection Of Installation Place
(1) Installation place shall meet the following and agreed by customers
• Place where proper air flow can be ensured.
• Noblock toair flow.
• Water drainage is smpoth.
• Place strong enough to support unit weight.
• Place where inclination is not evident on ceiling.
• Enough space for mainenance.
• Indoor and outdoor unit piping length is within limit. (Refer to Installation Manual for outdoor unit.)
• Indoor and outdoor unit, power cable, inter unit cable are at least 1m away fromT.V. radop. This is helpful to avoid
picture disturbance and noise. (Even if 1m iskept, noise can still appear if radio wave is strong)
(2) Ceiling height
Indoor unit can be installed on ceiling of 2.5-3m in height. (Refer to foeld setting and installation manual of
ornament panel.)
(3) Install suspending bolt.
Check if the installation place is strong enough to hold weight. Take necessary measures in case it is not safe.
(Distance between holes are marked on paper pattern. Refer to paper pattern for place need be reinforced)
AB25S2SC1FA AB35S2SC1FA AB50S2SC1FA
AB25S2SC2FA AB35S2SC2FA AB50S2SC2FA
AB50S2SF1FA
AB71S2SG1FA
AB50S2SF1FA AB71S2SG1FA
Model
21
H
320
320
236
257