Trouble Shooting; Help Line - RCA SystemLink 4 Manual

Sat 1 Manual 6/10/99 11:14 AM

Trouble Shooting

P R O B L E M
Red light not blinking when you press any key
The remote does not operate
your video devices
Not performing commands properly
Problems programming a TV/VCR
Combo Unit
VCR not recording
Channel up and down do not function on an
RCA TV
Problems changing channels
No response after pressing a key
SELECT button not responding
Reprogramming may be required after batteries are removed.

Help Line

If you need additional set-up help, please call the Satellite Remote Helpline at:
Page 15
S O L U T I O N
A) Replace the batteries (with fresh,
new AAA Alkaline batteries).
B) Check that batteries are properly installed.
A) Try all the codes listed for your brand.
B) Try the Code Search method (page 14).
Start Code Search over again to locate
the proper code for full compatibility.
Try the VCR code for your brand. Some
combo units, however, may require both
a TV and a VCR code for full operation.
As a safety feature on your remote, you must
press the REC button twice.
Due to some designs, only the original
remote will perform these functions.
If your original remote required ENTER after
a channel, press ENTER after you select a
channel.
A) Make sure you have new batteries and you
are aiming your remote at your devices.
B) Check that batteries are properly
installed. See page 3.
Try using the DISPLAY Button to make the
selection while in the Program Guide
1-800-420-7569
15