Technical Data; Assembling The Blender; Operating The Blender; Operating Instructions - AEG M 156 series Operating Instructions Manual

g
This appliance complies with the fol-
;
lowing EC directives:
• 73/23/EEC of 19/2/1973
„Low voltage directive", including
the Modification directive 93/68/EEC
• 89/336/EEC of 3/5/1989
„EMC directive", including
the Modification directive 92/31/EEC

Technical Data

Mains voltage: 230V
Power: 400W
2
Disposal
Dispose of the packaging!
Dispose the packaging material of your
appliance correctly. All packaging
materials are environmentally friendly
and can be disposed of without any
danger or burnt in the refuse incinera-
tor. The boxes are made from recycled
paper and should be returned to the
old paper collection.
Dispose of your old appliance!
When you eventually stop using your
appliance please bring it to the nearest
recycling centre or to your dealer who
will take it back for a small fee.

Operating instructions

The blender can be used for mixing liq-
uids, crushing ice, chopping, grinding
and grating of fruits and vegetables,
whipping cream etc.

Assembling the blender

To use the blender start by assembling
the jar, then place the jar on the motor
base as described below.
0 Place the rubber sealing ring on the
blade assembly (fig 2).
0 Position the blade assembly on the
inside of the jar (fig 3). Turn it anti-
clockwise to lock it tightly into posi-
8
tion. Important: There is a risk of
injury!
0 Position the jar on the base and turn it
clockwise to lock it into position
(fig 4).
0 Position the lid on the jar and turn it
clockwise to lock it into position
(fig 5).
3 Thanks to the 2-way safety system it is
only possible to operate the blender
when the jar and the lid are located in
the proper position (fig 4 and 5). See
also „2-way safety system".

Operating the blender

Always place the blender on a flat,
3
clean and non-slippery surface before
operating it.
0 Open the lid (fig 1/B) and add all nec-
essary ingredients to the blender jar.
Replace the lid and the pouring hole
cover. Important: Do not exceed the
maximum capacity!
Additional ingredients may be added
3
through the pouring hole while the
blender is operating. Always replace
the pouring hole lid to avoid splashing.
0 Start the blender by pressing one of
the speed buttons (fig 1/J) or the Pulse
button (fig 1/K).
It is advisable to start at speed setting
3
1 and then increase to speed 2 or 3.
Pushing the Pulse button will operate
the blender at the highest speed set-
ting.
0 When the blending is finished, turn the
jar anti-clockwise and lift it off the
base. Then turn the lid anti-clockwise
as well and remove the lid. Pour the
ingredients out through the spout.
Do not operate the blender longer than
1
2 minutes. After each the 2 minute
session the blender must be allowed to
cool down for at least 10 minutes.