Dry Vacuum Cleaning; Insert The Filter; Insert A Paper Filter If Required; Attach The Motor Head - Aeg Vampyr Multi Operating Instructions Manual

Dry vacuum cleaning

Preparation
Important: If the appliance has been used for
wet vacuum cleaning beforehand it must be
absolutely dry for this purpose; dry the hose and
pipes beforehand if necessary.
The motor protection filter must always be
inserted into the suction hole.
The thin hose attached to the motor head is
required only for spray vacuum cleaning.
When dry vacuum cleaning, press the end of the
hose into the retainer located on the motor head.

Insert the filter

0 First lift the foam filter then the fine paper filter
out of the filter basket and attach both filters by
pressing the tension ring.
Secure the tension ring by pivoting the two
brackets.

Insert a paper filter if required

In general a paper filter should be inserted when
dry vacuuming.
0 Hold the paper filter by the cardboard edge and
firmly press it onto the suction hole. The paper
filter must touch closely against the side of the
dust container wall so that it is not damaged by
the filter basket when gently replacing the
motor head.

Attach the motor head:

0 Motorkopf so auf den Schmutzbehälter
aufsetzen, dass sich die Schalter senkrecht über
der Ansaugöffnung befinden.Attach the motor
head onto the dust container such that the
switch islocated vertically above the suction
hole.
Then press the two vice action latches.
38