Snapper ELBX10152BV Operator's Manual

Snapper ELBX10152BV Operator's Manual

Assembly instructions parts list european extreme series walk-behind leaf blower series 2

Advertisement

Quick Links

A A S S S S E E M M B B L L Y Y I I N N S S T T R R U U C C T T I I O O N N S S
O O P P E E R R A A T T O O R R ' ' S S M M A A N N U U A A L L
P P A A R R T T S S L L I I S S T T
Actual product may differ slightly from product pictured above
Manual No. 7043324 (I.R. - 02/28/05)
European
Extreme Series
Walk-Behind
Leaf Blower
Series 2
Models Covered:
ELBX10152BV
(Part # 7085927)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ELBX10152BV and is the answer not in the manual?

Questions and answers

Summary of Contents for Snapper ELBX10152BV

  • Page 1 P P A A R R T T S S L L I I S S T T Actual product may differ slightly from product pictured above Manual No. 7043324 (I.R. - 02/28/05) European Extreme Series Walk-Behind Leaf Blower Series 2 Models Covered: ELBX10152BV (Part # 7085927)
  • Page 2: Model Number

    You have just purchased one of the finest pieces of outdoor power equipment on the market today. If properly cared for, your new blower will provide years of dependable service. Please read and follow this instruction manual carefully in order to get the most out of your new equipment.
  • Page 3: Slope Operation

    • Do not operate in reverse unless absolutely necessary. Always look down and behind before and while traveling in reverse. • Be aware of the blower discharge direction and do not point it at anyone. Do not operate the blower without deflec- tors in place.
  • Page 4: Maintenance And Storage

    safety rules regarding outdoor power equipment (cont.) CHILDREN Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the unit and its activity. Never assume that children will remain where you last saw them. •...
  • Page 5: Front Wheel Assembly

    Note: Please refer to Parts List for correct part identification and placement. FRONT WHEEL ASSEMBLY • Place Mounting Bracket against lower right corner of Blower Housing, aligning holes in bracket with threaded holes in housing. Secure with three 3/8-16 x 1 hex bolts, split lock washers and flat washers. securely.
  • Page 6: Starting The Engine

    unit operation STARTING THE ENGINE IMPORTANT NOTE: The procedures outlined within this section are general guidelines, and are in no way meant to replace or supercede engine manufacturer’s operating instructions. In order to obtain optimum performance from your engine, refer to your engine manual.
  • Page 7: Blower Operation

    BLOWER OPERATION DANGER! DO NOT PASS BY OR STAND ON THE AIR DISCHARGE SIDE OF ANY LEAF BLOWER WITH THE ENGINE RUNNING. HIGH VELOCITY DISCHARGE CAN EASILY TURN HARMLESS DEBRIS INTO FLYING PROJECTILES. DANGER! NEVER INSERT ANY BODY PART OR FOREIGN OBJECT INTO ANY OPENING WHILE UNIT IS RUNNING.
  • Page 8 For operator ease and maneuverability, push down on the upper handle while walking so that the machine balances on the rear wheels. • When blowing dry debris, set blower discharge to lower rate; when blowing wet or frozen debris, increase discharge rate. FRONT...
  • Page 9 LUBRICATION: • The tires on your blower contain bearings that should be lubricated on a weekly basis using a high-performance, auto- motive quality grease to ensure long life and minimal wear.
  • Page 10: Troubleshooting

    maintenance (cont.) BEFORE MAKING ANY ADJUSTMENTS, STOP ENGINE AND DISCONNECT SPARK PLUG WIRE TO PREVENT INADVERTENT STARTING OF UNIT. TROUBLESHOOTING: • UNIT WILL NOT START: • Check fuel and oil levels. • Check to make sure choke is set when engine is cold, off when hot. •...
  • Page 11: Replacement Parts

    maintenance (cont.) ADJUSTMENTS: BEFORE MAKING ANY ADJUSTMENTS, STOP ENGINE AND DISCONNECT SPARK PLUG WIRE TO PREVENT INADVERTENT STARTING OF UNIT. • THROTTLE CABLE ADJUSTMENT: adjustment allows for full range of movement of throttle body on engine in conjunction with throttle control on handle.
  • Page 12 illustrated parts list...
  • Page 13 (cont.) Item Part No. Description 7043267 WELDMENT, Housing- Extreme Blower, LBX10152BV 75892 DECAL - Danger-Flying Material - See DECAL IDENTIFICATION 3039111 ENGINE, B&S 10HP Intek OHV 3071815 SCREW, Clamp Casing, Briggs Intek Engine (Not Shown) 3071814 CLAMP, Casing, Briggs Intek Engine (Not Shown) 91581 SCREW, 8-18 x 1-1/2”...
  • Page 14 DECAL - Euro Certification - See DECAL IDENTIFICATION 7078087 DECAL - Extreme Logo - See DECAL IDENTIFICATION 27255 DECAL - Snapper Logo - See DECAL IDENTIFICATION 1722551 DECAL - Simplicity Logo - See DECAL IDENTIFICATION 73462 DECAL - Warning Combo - See DECAL IDENTIFICATION...
  • Page 15 LOCATED ON SIDE OF BLOWER HOUSING 7078069 - NOISE RATING - LOCATED ON REAR OF BLOWER HOUSING 75893 - EAR/EYE/BREATHING PROTECTION REQUIRED - LOCATED ON SIDE OF BLOWER HOUSING 22841 - WARNING-CUT FINGER - LOCATED ABOVE BLOWER DISCHARGE 7011279 - MODEL YEAR 2005 - LOCATED...
  • Page 16 LOCATED ON INTAKE BAFFLE EUROPEAN PERFORMANCE: Maximum level of vibration measured at the operator’s hand 16 m/sec2 27255 - SNAPPER LOGO - LOCATED ON MID- HANDLE PANEL (ON APPLICABLE MODELS) 1722551 - SIMPLICITY LOGO - LOCATED ON MID-HANDLE PANEL (ON APPLICABLE MODELS)
  • Page 17 notes...
  • Page 18 notes...
  • Page 19 notes...
  • Page 20 O O P P E E R R A A T T O O R R ’ ’ S S M M A A N N U U A A L L P P A A R R T T S S L L I I S S T T European Extreme Series Walk-Behind Leaf Blower Series 2 McDonough, GA 30253 USA Manual No. 7043324 (I.R. - 02/28/05)

Table of Contents