There is no picture or sound on the TV.
The unit does not turn on.
The unit does not connect
to A/V equipment
correctly, or there is no
A/V signal from the A/V
frequency is different
from the receiver's.
No signal reaches the
The TV is not set to the
c Make sure to turn on the transmitter and receiver.
c Make sure to connect the transmitter to the AC power adaptor,
and then to a wall outlet.
c Make sure to connect the receiver to the AC power adaptor, and
then to a wall outlet.
c Make sure to connect the transmitter to the A/V equipment.
c Make sure to connect the receiver to the TV, and the receiver to
the dedicated antenna.
c Turn on the A/V equipment connected to the transmitter and
c Make sure to set the CHANNEL switch of the transmitter and
receiver to the same position.
c Adjust the direction of the dedicated antenna (page 12).
c Set the transmitter closer to the dedicated antenna.
c If there are any obstacles (especially metallic) between the
transmitter and the receiver, remove them.
c Reorient the dedicated antenna to minimize the problem (page
c When you are using a microwave oven near the dedicated
antenna, electromagnetic interference occurs in the unit, but
stops if you stop using the microwave oven.
c When you are using a cordless phone, a wireless LAN,
Bluetooth equipment such as same frequency (2.4 GHz)
wireless equipment as the unit near the dedicated antenna,
change the CHANNEL switch (frequency) to another frequency
to avoid interference, or set the unit away from the interfering
c Set the TV to the appropriate input.