Download  Print this page

Installing The Ir Blaster - Sony HWS-AV10K Operating Instructions Manual

Home wireless a/v system.
Hide thumbs

Advertisement

Table of Contents

Installing the IR Blaster

You can operate the A/V equipment connected to the transmitter using the remote control in
another room.
Another room
PLAY
Set the IR Blaster by the following procedure.
1
Put the supplied double sided seal on the IR Blaster.
Do not remove the opposite face of the double sided seal yet. You can also use a
store-bought double sided seal.
2
Connect the IR Blaster to the IR EXTENDER jack on the rear of the
transmitter.
Do not connect the other of supplied IR Blaster.
3
Position the IR Blaster above the infrared receiver on the A/V
equipment.
To locate the infrared receiver, see the instruction manual for the connected A/V
equipment. Make sure to place the IR Blaster just above the infrared receiver.
4
Perform the operation test.
Point and operate the remote control of A/V equipment at the receiver's infrared receiver,
and check the performance of the connected A/V equipment correctly.
5
Fix the IR Blaster.
After performing the operation test on the connected A/V equipment, remove the opposite
face of the double sided seal, and then fix the IR Blaster in the installation in step 3.
Notes
• Some A/V equipment may not operate correctly, depending on the installation location. Install the IR
Blaster and A/V equipment's infrared receiver as close as possible.
• If other A/V equipment is nearby the transmitter, accidental wrong operation of this A/V equipment may
occur due to the location of the IR Blaster. In this case, change the installation location of the IR Blaster.
• If you place the transmitter too close to the receiver, the signal may be looped from the receiver back to
the transmitter. In this case, place the receiver further apart from the transmitter.
Control signal
Double sided seal
A/V equipment
Infrared emitter
Infrared receiver
A/V equipment's room
PLAY
13
US

Advertisement

Chapters

Table of Contents

   Related Manuals for Sony HWS-AV10K

Comments to this Manuals

Symbols: 0
Latest comments: