Briggs & Stratton 1694923 Installation Instructions

Installation
Instructions
2
1
Figure 1. Contents
This kit is to install a bumper onto a Regent / 500 /
2500 / LT-200 Series Lawn Tractor.
WARNING
Before beginning any service work turn off the
PTO, set the parking brake, turn off the ignition,
and disconnect the spark plug wire(s).
Kit Installation
HOOD REMOVAL
1. Open the hood.
2. Remove the socket and bulbs (A, Figure 2) by twist-
ing the socket counterclockwise and pulling it out of
the bezel (B). Repeat on other side.
3. Rock the hood back slightly and lift hood and grill
assembly (B, Figure 3) off pivot posts (C). Set hood
on clean 4 x 4's or workbench.
3
3
2
Kit Contents:
Ref. Part No. Qty.
1 1731989A 1
2 1931277 4
3 1930591 4
B
Figure 2. Head Light
A. Socket and Bulbs
B. Bezel
B
D
A
Figure 3. Hood Removal and Installation
A. Hinge Post
B. Hood and Grill Assembly
C. Pivot Post
D. Stop
1
Bumper Kit
Mfg. No. 1694923
Description
Bumper Assembly
Nut, Hex, Flange Lock, 5/16-18
Capscrew, Flange Lock,
5/16-18 x 3/4
A
A
C