Advertisement
Available languages
Available languages
Advices for
operation
Hints
Maintenance
Accessories
ENGLISH
Exerting greater pressure does not increase the machine's effectiveness!
The Anti–Vibration–System will work at an
optimum when normal working pressure is
applied; the shock absorber is then only
slightly pressed together.
If the applied working pressure is too high,
the shock absorber is strongly pushed
together and the vibrations are noticeably
transmitted to the handle.
Take the drill out of the hole from time to time to remove dust.
Switch to percussion-drilling for concrete, hard bricks and tiles, stone, hard cement,
and marble (but not when drilling the surface of marble).
For tiles, paving-stones, soft bricks and tiles, soft cement, breeze-block and plaster,
switch to normal drilling.
Use percussion carbide tipped masonry drill-bits.
When drilling a hard, smooth surface (e.g. tiles), cover the point to be drilled with
adhesive tape in order to prevent the drill bit tip from skidding.
Should the hammer action deteriorate send it to one of our Service Stations.
The ventilation slots of the machine must be kept clear at all times.
The machine is fitted with carbon brush that automatically switch it off if they are
worn, before the motor can be damaged.
If the carbon brushes cut-out or the hammer capacity declines please contact your
authorized AEG service station. This will ensure long service life as well as constant
readiness for working of the machine.
The location of your neerest service station is shown in our "Service adresses" leaflet
attached to each product.
Use only AEG accessories and spare parts. Should components need to be
replaced which have not been described, please contact one of our AEG service
agents (see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please state the ten–digit
No. as well as the machine type printed on the label and order the drawing at your
local service agents or directly at: Atlas Copco Elektrowerkzeuge GmbH,
Postfach 320, D–71361 Winnenden.
The range of accessories with part numbers is shown in our catalogue.
5
PNEUMATIC 6000 S
Advertisement
