This appliance cannot be positioned on a
The following instructions are meant for a qualified
installer, in order that the operations of installation,
regulation, and service are executed according to the
Before using the unit, take off the special protective layer
which protects the stainless steel and anodyzed tin
parts. Whenever changes are mode involving the
disconnection of the machine it is necessary to proceed
with maximum caution.
THE MANUFACTURING COMPANY DECLINES
ANY RESPONSABILITY FOR POSSIBLE
INSTALLATION WHICH DOES NOT COMPLY
WITH THE RULES IN FORCE.
Warning - This unit can be installed and can work only
in constantly ventilated rooms, according to rules in
In order to make the gas unit work properly, it is
necessary that air sufficient to gas combustion can
naturally flow in the room. (The installer must follow the
rules in force).
The air flow into the room must come directly through
openings of external walls. These openings (or opening)
should be made in such a way not to be occluded both
from inside and outside.
Installation and maintenance must be carried out by a
qualified technician, in compliance with the rules in force.
The electric coonection must be carried out in
compliance rules in force.
Our responsability will not be involved in case of
accidents caused by a defective or non existent
Combustion products discharge
Gas cooking units must discharge combustion products
through hoods directly connected to flues or outside.
This appliance has been designed to be placed close to
furniture units not exceeding the height of the working
In case of insertion of the appliance between kitchen
units, the dimensions to be respected are shown in the
When the kitchen is installed according to class 2, sub-
class 1 (i.e. built-in) for the gas connection use only
flexible metallic tubes conforming to rules in force.
1. Remove the hob pan supports, the burner caps and
2. Carefully lean the cooker on its back, paying attention
3. Adjust the feet height by unscrewing the bottom part
4. Insert the feet into the relevant holes indicated in the
5. Lift the cooker in vertical position. Replace the crowns,
6. If necessary, adjust the cooker horizontally levelling
Before installing the cooker, it is necessary to
assemble the supplied feet.
crowns and the oven accessories.
not to cause any damage.
of each foot, until you obtain the required height (height
can be adjusted from 850 to 880 mm).
the burner caps, the hob pan supports and the oven
by turning the bottom part of the feet, until the
appliance is completely stable.