Siemens CPU 31 Series Technical Data Manual page 92

Cycle and reaction times
5.2 Cycle time
Operating system processing time at the scan cycle check point
The table below shows the operating system processing time at the scan cycle checkpoint of
the CPUs. These times are calculated without taking into consideration times for:
• Testing and commissioning routines, e.g. status/controlling of variables or block status
• Transfer and deletion of blocks, compressing user program memory
• Communication
• Writing, reading of the SIMATIC Micro Memory Card with SFC 82 to 84
Table 5-6
CPU
312C
313C
313C-2
314C-2
312
314
315
317
319
Extension of the cycle time as a result of nested interrupts
Enabled interrupts also extend cycle time. Details are found in the table below.
Table 5-7
Interrupt type
312C
313C
313C-2
314C-2
312
314
315
317
319
The program runtime at interrupt level must be added to this time extension.
5-6
functions
Operating system processing time at the scan cycle check point
Extended cycle time due to nested interrupts
Process
interrupt
700 μs
500 μs
500 μs
500 μs
700 μs
500 μs
500 μs
190 μs
72 μs
Cycle control at the scan cycle check point (CCP)
500 μs
500 μs
500 μs
500 μs
500 μs
500 μs
500 μs
150 μs
77 μs
Diagnostic Time-of-day
Interrupt interrupt
700 μs 600 μs
600 μs 400 μs
600 μs 400 μs
600 μs 400 μs
700 μs 600 μs
600 μs 400 μs
600 μs 400 μs
240 μs 200 μs
87 μs 39 μs
Delay interrupt Watchdog
interrupt
400 μs 250 μs
300 μs 150 μs
300 μs 150 μs
300 μs 150 μs
400 μs 250 μs
300 μs 150 μs
300 μs 150 μs
150 μs 90 μs
26 μs 10 μs
CPU 31xC and CPU 31x, Technical Data
Manual, 01/2006 Edition, A5E00105475-06