Setup Selections - Fluke 187 Getting Started

Model 187 & 189
Getting Started

Setup Selections

The meter allows you to change the default operating
configuration of the meter by changing setup options
made at the factory. Many of these setup options affect
general meter operations and are active in all functions.
Others are limited to one function or group of functions.
To enter the Setup mode, turn the meter on and press
O T (SETUP). In the Setup mode, each press of
O T (SETUP) saves changes to the last selection
and steps to the next option.
Selection Precondition
000.0 °C
Temperature (
or selected.
000.0 °F
L Int
Model 189 only.
\
dbrEF
AC volts (
,
) selected.
\
dbrEF
AC volts (
,
) and dBm
selected.
14
Table 4. Function Specific Setup Selections
Option
w
) Temperature
offset adjust
Log interval
or dB type
or dBm reference
Each setup option appears in the primary display in the
sequence shown in Tables 4 and 5.
The options in Table 4 are available only when the
preconditions are met. The options in Table 5 are
available for all functions. (When measuring dc volts,
none of the preconditions in Table 4 are required, and
only the selections shown in Table 5 will appear.)
To exit the Setup mode, Press O N (CANCEL).
Be sure to save your last selection by pressing O T
first.
< >
Choices (
q
000.0 ° to ±999.9 ° - Use
decrement digit.
< >
Use to select digit. Selected digit
flashes.
q
MM:SS - Use to increment or decrement
minute or second values.
< >
Use to select minute or seconds.
Selected values flash.
dBm or dBV (m or V flashing) - Use
select.
q
0001 Ω to 1999 Ω - Use
decrement digit.
< >
Use to select digit.
) Factory Default
000.0 °C (or °F)
to increment or
15:00
< >
to dBV
0600 Ω
to increment or