Download Print this page

Makita 4350T Technical Information page 9

Hide thumbs

Advertisement

R
epair
[10] Assembling parts in Gear housing
1. Pass the shaft of Gear housing through Flat washer 8. (Fig. 26)
2. After assembling Seal plate to Push plate, pass the shaft of Gear housing through Push plate with Seal plate. (Fig. 27)
3. Lubricate the parts with referring to [1] Lubrication in page 2.
4. Pass the shaft of Gear housing through Gear complete and Balance plate. (Fig. 28)
5. Assemble Crank complete to Gear housing. Push down Crank complete while turning it until the groove on
shaft of Gear housing can be seen. (Fig. 29)
6. While locking crank complete with 1R235, fasten Crank complete with two M4x12 Hex socket head bolts with
adhesive. (Fig. 30)
Note: Do not fasten Crank complete with the used M4x12 Hex socket head bolts. Use new M4x12 Hex socket head bolts
with adhesive. The fastening torque of these bolts has to be 2.4 - 3.5 N.m.
7. Install Retaining ring S-8 to the groove on the shaft of Gear housing using 1R291 to secure the components. (Fig. 31)
Fig. 26
Shaft of Gear housing
Flat
washer 8
Fig. 29
Groove on the shaft of Gear housing
for Retaining ring S-8
Crank complete
Press down Crank complete until the groove
on the shaft of Gear housing can be seen.
Fig. 31
Retaining ring S-8
Fig. 27
Shaft of Gear housing
Push plate
Seal plate
Gear housing
Fig. 30
Balance plate
Crank complete
Balance plate
Gear complete
Push plate
Flat washer 8
Seal plate
Fig. 28
Balance
plate
Gear complete
M4x12 Hex socket head bolts
1R235
Retaining ring S-8
P 9 / 14
Shaft of Gear housing
Crank complete

Advertisement

loading

This manual is also suitable for:

4350ct4350fct