Advertisement
R
epair
[6] Assembling Gear housing cover section
1. Assemble Tool opener to Gear housing cover with referring to Figs. 1, 2 and 3 in page 3.
2. Put Leaf spring in Gear housing cover. Pay attention to its assembling direction. (Fig. 9)
Insert Rod into Gear housing cover. Pay attention to the direction of the hook of Blade holder as illustrated in Fig. 10.
Fig. 9
Tool opener
Rod
ass'y
Hook of Blade holder
3. After aligning the holes of Slider and Rod, insert Pin 4 into the aligned hole from left side as illustrated in Fig. 11.
4. Recline Slider fully and insert a pair of Linear guides as illustrated in Fig. 12.
Fig. 11
Hole of Rod
Holes of Slider
5. While lifting up the flat side of Leaf spring, lay a pair of Linear guides to put the flat side of Leaf spring on Linear
guides as illustrated in Fig. 13.
6. Move Slider to the center of Linear guides. Fasten Linear guides with four M4x10 Pan head screws as illustrated in Fig. 14.
Fig. 13
Lay Linear guides.
Lift up the flat side
of Leaf spring.
Fig. 14
Move Slider to the
center of Linear guides.
The two protrusions in
the Gear housing cover
Gear housing cover
Leaf spring
Face the roll portion
to the opposite side
of Gear housing cover
Face the hook of Blade
holder to the hook of
Tool opener when installing
Rod ass'y. Refer to Fig. 10.
Pin 4
(to the aligned hole)
Cross section of Gear housing cover
Linear guides
Gear housing cover
M4x10 Pan head screws
The ends of Linear guides
Fig. 10
Tool opener viewed from the bottom side
Hook of Blade holder
Gear housing cover
Fig. 12
Linear guides
Slider
Slider
Leaf spring
Note: Attach the ends of Linear guides to the two protrusions
in the Gear housing cover when fastening them.
P 5 / 14
Hook of Tool opener
Inside of Gear housing cover
Note: Linear guides have to be
put between Gear housing
cover and the flat side of
Leaf spring.
Advertisement
