Download Print this page

Makita 4350T Technical Information page 4

Hide thumbs

Advertisement

R
epair
[5] Disassembling Gear housing cover section
1. After separating Safety wire from Gear housing cover, remove four CT 4x16 Tapping screws.
Gear housing cover and Packing are separated from Gear housing with Motor housing as illustrated in Fig. 6.
Fig. 6
CT 4x16 Tapping screws
2. Remove Stop ring E-3 with slotted screwdriver.
Push Slider to the lower dead point. (Fig. 7)
Fig. 7
Inside of Gear housing cover
Slider
Pin 4
Rod
3. Slide Pin 4 in order to disconnect Rod with Slider. And then, pull out Rod from Gear housing cover.
Separate Linear guides from Gear housing by removing four M4x10 Pan head screws.
Pin 4, Slider and Leaf spring are disassembled from Gear housing cover. (Fig. 8)
Fig. 8
Linear guides
Slider
Pin 4
Note: Pay attention to the direction of Leaf spring illustrated above when reassembling.
Gear housing cover
Packing
Stop ring E-3
Rod
Gear housing cover
Rod
Gear housing
Slider in the lower
dead point
Linear guides
Leaf spring
Slider
Pin 4
M4x10 Pan head
screws
P 4 / 14

Advertisement

loading

This manual is also suitable for:

4350ct4350fct