Problem Solving Guide - Miele CS 1421 Operating And Installation Instructions

With the aid of the following guide, minor problems can be easily corrected
without contacting Miele.
If having followed the suggestions below, you still cannot resolve the problem,
please contact Miele (see end of this booklet for contact details).

Danger of injury. Installation, maintenance and repairs may only be carried
out by a suitably qualified and competent person.
Repairs and other work by unqualified persons could be dangerous. Miele can-
not be held liable for unauthorised work.
Do not attempt to open the casing of the CombiSet yourself.
Problem
You cannot raise the
browning unit.
The salamander does
not heat up
The heating element is
switching on and off.
When setting '12' is se-
lected, the appliance
does not become hot
enough for the food to
start browning
Cause and remedy
Food deposits have hardened or something has be-
come stuck in the gap around the browning unit.
 Clean the browning unit.
The mains fuse has tripped.
 If it has, contact a qualified electrician or Miele
Service.
The browning unit is not in the correct position.
 Check that the browning unit is raised sufficiently.
It must be raised by at least 70 mm.
 Make sure the standing surface has been inserted
and is positioned correctly.
There was an interruption to the power supply during
operation, and the heating has switched itself off.
 To operate the appliance again, turn the control
"0".
Lower the browning unit fully.
This takting is quite normal and does not indicate in-
correct operation or a fault with the appliance.
The appliance operates at a lower power level when
the control is positioned between the "12" and the
"0".
 Check that the mark on the control is exactly posi-
tioned at the "12".

Problem solving guide

23