Husqvarna S 36 Operator's Manual page 10

Operation
Note 1: Service more frequently when used in dusty areas.
Note 2: Change engine oil after first 8 hours, then every 50 hours.
Note 3: Change engine oil filter after first 8 hours, then follow maintenance instructions according to engine manu-
facturer manual.
Before you change the filter
• Clean the filter according to instructions in section
clean the filter on page 9 .
• Turn off the engine and wait for the fan to completely
stop before opening the dust extractor to change
filters. The exhaust will get very hot after running the
engine for just a short time.
To change the HEPA filter
CAUTION: Do not clean HEPA filters. Trying
to clean a HEPA filter will destroy it. When
installing the replacement filter, make sure to
not touch the inside of the filter. Any kind of
force/damage on the inside of filter media
will destroy the new filter.
Note: Recommended intervals for filter change: Pre-filter
every 6 months and HEPA filters every 12 months.
1. Loosen the latches on the filter cover cap.
2. Carefully lift the filter into a clean plastic bag, this
bag must be properly disposed.
3. Insert a new filter in reverse order.
To change the pre-filter, T 8600 Propane
WARNING: Switch off the dust extractor.
1. Loosen the two latches between the tank and the
lower cyclone.
2. Loosen the two latches at the hose connection
between the tank and the HEPA filter cover.
3. Rotate the tank forwards.
4. Rotate the filter plate counterclockwise 10 degrees
and carefully turn the filter and holder upside down.
5. Place a plastic bag over the filter unit.
6. Lift the filter carefully and pinch up the bag by hand
and then tie the bag up. This bag must be properly
disposed of.
10
Daily
7. Insert a new complete filter pack in reverse order.
Only original filters may be used.
To
To change the pre-filter, S 36 Propane
CAUTION: When you remove the pre-filter in
order to clean it, use only low pressure water
from the inside through to the out. Hitting the
filter with force, high pressure water or use
of compressed air will destroy the filter. The
filter must be 100% dry before returning into
the housing.
1. Loosen the 3 clamps and remove the top.
2. Take the bag from the new filter.
3. Lift out the filter and place it gently in a plastic bag.
This bag must be properly disposed.
4. Insert a new filter.
To assemble a new LONGOPAC bag
CAUTION: All dust extractors can be used
with original Husqvarna dust bags for single
use. Also all models can be fitted with the
LONGOPAC system. Only change
LONGOPAC or regular bags after the filter
cleaning cycle has been completed.
The dust extractors are mainly equipped with a
LONGOPAC system for effective dust storage or a
regular plastic bag system depending on model.
LONGOPAC is a 72 ft (22 m) long plastic tube that will
be divided into plastic bags using the zip ties attached
with the product.
1. Release the belt holding the last bag.
2. Remove the holder, put in a new LONGOPAC bag
and pull out the inner end upwards.
3. Assemble the holder onto the dust extractor and
strap the opening facing upwards to the belt.
4. Pull down the outside end and close it using a zip tie.
8 Hrs. 50 hrs.
518 - 003 - 07.06.2018