Status Bar Icons Description - Naturela NPBC-V3C-1 User Manual

Electronic pellet burner controller

Hide thumbs Also See for NPBC-V3C-1:

Technical manual (9 pages)

Manual (37 pages)

Table Of Contents

Table of Contents

Electronic pellet burner controller – NPBC-V3C-1/ NPBC-V4C-1

for errors. If several messages are to be displayed at the same time, they switch on every 4 seconds.

The time must be set correctly for the burner to function properly. If it hasn't been set yet, its

indication is --:--.

Most of the error messages that appear in red at the bottom of the main screen are indicated

by a three-toned sound signalization. In some cases the error message disappears soon after

the problem is resolved. However, there are some errors that if occur, remain on the screen

until the user dismisses them manually. Examples for such messages are "Back burning",

"Boiler Frost", etc. They can be cleaned only by holding the left navigation button ( ◄ )

pressed for 2 seconds, while on main screen

Customized information fields could display any of the following parameters:

Icon

Level of illumination, measured by the photo sensor.

Exhaust fan's speed

Information about the upcoming action of the timer. If there are no active

timers or the burner is in Standby mode, there is no information under the

icon. If there is at least one activated timer and the burner is ON, regardless

of the fuel type, the upcoming action (On/Off) and the time for it (or the

day of the week if it is after 23:59 pm on the current day) are displayed

under the icon.

Current calculated power of the burner. A calibrating constant parameter

for the auger motor's capacity must be set to assure the correct value of the

burner's power. The calibrating constant is available in the menu Factory

Settings → General Settings → Feeder capacity

Temperature measured by the temperature sensor in the water heater

Temperature measured by the exhaust gases high temperature sensor