4. Run the pump dry approximately 10 sec- can see if there is any leakage around the vent onds to drain the water before exposure to cap (on the top of the pump). freezing temperatures. NOTE: Contact Giant Industries for Service School Information. Phone: (419)-531-4600...
REPAIR INSTRUCTION - GXR SERIES 1. With a 14mm socket wrench, 3. With a crescent wrench, 2. Remove the valve spring remove the three discharge remove the injector retainer (18) and valve cone (36) valve plugs (27). Inspect (47). Inspect the o-ring (46) from the manifold (35).
Page 7
GXR SERIES REPAIR INSTRUCTIONS 11. Remove the guided p-valve, (19), valve springs (18), v-sleeves 12. If the crankcase oil seals (15) are to be replaced, they can (21) and pressure rings (20). Inspect for wear and replace as necessary. Remove the spacer ring (17) from the be removed by prying loose with a screwdriver.
A Returned Goods Authorization (R.G.A.) number and completed warranty evaluation form is required prior to the return to Giant Industries of all products under war- ranty consideration. Call (419)-531-4600 or fax (419)-531-6836 to obtain an R.G.A. number.