Canon imageRUNNER iR2270 Service Manual page 28

The URL of the LMS
http://www.canon.com/lms/ir/
Memo:
When users obtain a license key, both the 24-digit number on the license access number
card and the serial No. (e.g.: ABC01234) of the device to be installed are required. The
device serial No. is displayed in the "Serial No." when the counter key of the iR is pressed.
(2) Write down the 24-digit number displayed on the Web in the space provided on the
license access number certificate sheet.
Memo:
Make sure to transcribe correctly. Give an appropriate explanation to users so that they will
keep the license access number cards surely.
(3) Press the Additional function>System settings>License Registration, then input the
license key in the designated space, and press Start key so that the license key is registered
and the function of the option is validated.
If the function fails to be validated, an error message will be displayed. Refer to the
followings what action to be required.
"There are not enough required features for install."
>> Check if the USB Application Interface Board-D1 is recognized correctly and also check
if the RAM capacity is 512MB.
"The value for the license key is incorrect. Check the license key."
>>Check if the license key issued to another device is used.
>>Check if the license key is input wrongly.
>>Check if the license key is correct.
"This function has already enabled."
>>Check if the security function has already been enabled.
(4) Press the power switch on the control panel for 3 seconds or more. Following the
instructions displayed on the shutdown sequence step by step with operations to select
appropriate items on the touch panel so that the main switch can be ready for turning off.