Advertisement
Preparing to download the
version update data
Make sure that you have an appropriate SmartMedia
card or USB flash memory device, formatted for use
on the STAGEA, and having enough free space for the
version update data.
* If a previous version update data has already been
loaded to SmartMedia or USB flash memory, the
version update data on the media/device will be
deleted and replaced with the new data.
■ For those using USB flash memory
for updating
If the current version of your STAGEA is earlier than
1.60, installing the version update data is not possible
by using USB flash memory. Start the operation by
first checking the version of your STAGEA and
making sure that the version is 1.60 or later.
Check that the USB memory device (other USB flash
memory or USB-FDD, etc.) is not connected and
that a SmartMedia card is not inserted to/in the
STAGEA.
• No USB memory device is connected and no
SmartMedia card is inserted.
There is no problem. Go on to the download
operation.
• SmartMedia card is inserted.
Please pull out the SmartMedia card until the
installation is completed.
• USB memory device is connected.
Please disconnect it until the installation is
completed. As for a USB-FDD (floppy disk drive),
as long as a floppy disk is not inserted, there is no
problem.
* We recommend that you connect USB flash
memory directly to the STAGEA, and not via a
USB hub.
■ If there is not enough empty capacity
in SmartMedia or USB flash memory
• You can delete unnecessary data (registration data,
etc.) with the STAGEA.
• If you don't have the appropriate SmartMedia card
or USB flash memory, you'll have to purchase it.
Please use the SmartMedia card or USB flash
memory which has been formatted on the
STAGEA.
Downloading the version update
data
■ Method A
Using Internet Direct Connection
Cable / Wireless connection
(INTERNET)
Please access the Internet from the STAGEA and start
the operation from the top page.
Insert the SmartMedia or USB flash memory in the
STAGEA and press "STAGEA's version upgrade",
then the download button on the display.
A "downloading..." message appears when the
download starts, and a "Download completed"
message is shown when the download has been
properly completed.
The time necessary for downloading differs depending
on your Internet connection and provider. In some
cases, this may take more than ten minutes.
For more information on using Internet Direct
Connection, refer to the STAGEA Owner's Manual.
Please go on to the next step when the download is
completed.
■ Method B
Using computer with Internet connection
(INTERNET)
PC
* Only USB flash memory is applicable on the ELS-
01/01C typeU.
• Download the update data to your computer
Windows:
Access
http://asia.yamaha.com/en/products/musical-
instruments/keyboards/electone/, select your model
(If you are using the ELS-01C or -01C typeU, select
"ELS-01C typeU." If you are using the ELS-01 or -01
typeU, select "ELS-01 typeU."), click 'Support' tab,
then download the version update data, and finally
save the file "els-01_01c_01x_v***.exe" ("v***"
or
SmartMedia card
or
STAGEA
USB flash memory
2
Advertisement
