4.1 Free-Standing Version .................................................................................................................................. 17
4.2 Fully Built-In Version ..................................................................................................................................... 18
PIPELINES ARE NOT DAMAGED UNTIL THE COMPETENT SERVICE HAS TAKEN DELIVERY OF THE APPLIANCE. BEFORE SCRAPPING YOUR REFRIGERATOR IT IS IMPORTANT TO REMOVE DOORS AND LEAVE SHELVES IN POSITION AS FOR USE, TO ENSURE THAT CHILDREN CANNOT ACCIDENTALLY BECOME TRAPPED INSIDE DURING PLAY. ALSO, CUT THE POWER SUPPLY LEAD AND REMOVE IT AND THE PLUG.
Precautions for Use 2. PRECAUTIONS FOR USE ELECTRICAL CONNECTION: SEE INSTALLATION INSTRUCTIONS FOR SAFETY REGULATIONS FOR ELECTRIC OR GAS APPLIANCES AND FOR VENTILATION FUNCTIONS. IN YOUR INTEREST AND TO ENSURE YOUR SAFETY, BY LAW ALL ELECTRIC APPLIANCES MUST ONLY BE INSTALLED AND SERVICED BY QUALIFIED STAFF, IN ACCORDANCE WITH THE RELEVANT REGULATIONS.
Safety Precautions 3. SAFETY PRECAUTIONS INSTRUCTIONS FOR THE INSTALLER: THESE ARE INTENDED FOR THE QUALIFIED ENGINEER WHO IS TO INSTALL, COMMISSION AND TEST THE APPLIANCE. THE APPLIANCE MUST BE INSTALLED BY QUALIFIED STAFF TO PREVENT DAMAGE OR INJURY. THE REFRIGERANT IN THE APPLIANCE'S CIRCUIT CONTAINS NH3 (AMMONIUM) AND IS TOXIC AND FLAMMABLE: TAKE CARE NOT TO DAMAGE THE REFRIGERATION CIRCUIT.
Instructions for the Installer 4. INSTALLATION AND CONNECTION Regardless of the installation method (free-standing or built-in), always check that the appliance is per- fectly lev-el after installation. 4.1 Free-Standing Version After removing the packaging, tilt the appliance onto its back and fit the four wheels supplied onto the pins provided in the base.
4.2 Fully Built-In Version Minibars can easily be built into any suitable cabinet. It is essential to comply with the following guidelines: 1 Make sure that sufficient ventilation can reach the refrigeration unit, on the rear of the minibar. 2 Sketches A, B and C (fig. 2) show various alternatives for building-in your minibar; 3 The ventilation gaps, for both incoming and outgoing air, must measure at least 200 cm indispensable to take care that any ventilation grilles cannot be obstructed in any way.
Page 7
Instructions for the Installer Place the minibar and cabinet doors open at 90° and bring their ends together (fig. 5). In this position, fix the L-shaped bracket to the door of the minibar. Before screwing the L- shaped bracket into place, fit the linking bracket as shown in the diagram.
Instructions for the Installer 4.3 Built-In Version Without Added Door See below for the overall dimensions of the minibar (Fig. 8) and the relative dimensions required for the cabinet which is to house it (Fig. 9). The area of both the air intakes and outlets must be at least 200 cm 4.4 Electricity Supply The appliance must be connected, by means of its own power supply lead, to a regulation mains socket with earth connection.
5. USING THE MINIBAR To switch the refrigerator on, turn the knob of the thermostat in the bottom left-hand corner inside the appliance. When the knob is turned to 0, the appliance is switched off. The operating settings are from 1 (highest inside temperature) to 7 (lowest inside temperature).