Siemens SIMATIC NET Operating Instructions Manual page 46

Approvals
● Keep to the installation guidelines
The devices meet the requirements if you adhere to the installation and safety
instructions contained in this documentation and in the following documentation when
installing and operating the devices.
● You can always find the latest documentation on the Internet
The current descriptions of the currently available products can always be found on the
Internet under the specified entry IDs/Internet pages:
– "Industrial Ethernet / PROFINET Industrial Ethernet" System Manual
– "Industrial Ethernet / PROFINET - Passive network components" System Manual
– "EMC Installation Guidelines" configuration manual
● Working on the device
To protect the device from electrostatic discharge, personnel must first discharge any
electrostatic charge from their body before touching the device.
Note
The test was performed with a device and a connected communications partner that also
meets the requirements of the standards listed above.
When operating the device with a communications partner that does not comply with
these standards, adherence to the corresponding values cannot be guaranteed.
Safety of electrical equipment
In the version put into circulation by Siemens AG, the SIMATIC NET products described in
these Operating Instructions conform to the regulations of the following European directive:
● EN 60950-1
Information technology equipment - Safety - Part 1: General requirements
46
You will find information on the system manuals in the section "Introduction (Page 5)",
in "Further documentation".
ID = 60612658 (http://support.automation.siemens.com/WW/view/en/60612658)
Extender for SCALANCE XM-400
Operating Instructions, 05/2014, C79000-G8976-C332-03